(完整版)土木工程框架结构设计毕业论文设计.doc

优秀论文 审核通过 未经允许 切勿外传 毕业设计（论文） 某公司办公楼 学生姓名： 学 号： 专业班级： 指导教师： 20 年 月 日 摘 要 本课题为东营市华凌科技办公楼的设计， 4 层，建筑面积约 3000m2， 长 42m，宽 16.8m，高 14.95m。采用钢筋混凝土框架结构。首先，根据设计出的建筑方案及所选用的建筑材料及做法，确定结构计算简图，进行荷载和内力计算，绘制了相应的内力图；其次，进行结构内力组合，确定结构控制截面的弯矩、剪力和轴力设计值。最后，根据已经计算出的结构控制截面的内力值，对梁、板、柱、基础等进行配筋计算，并绘制了相应的结构施工图。同时，本文采用 PKPM 软件进行电算，以保证计算结果的可靠性，并达到同手算结果对比、分析的目的。 关键词：框架结构；内力；配筋；控制截面 ABSTRACT The topic is the design of Hua Ling technology office building in DongYing city, four layers, the area of construction is about 3000m2, the length of the building is 42m, the width is 16.8m and the , building material and method, determine schematic calculation, thus completing the load and internal forces calculation, drawing a map correspondingto the internal forces; Secondly, proceed the structure internal force combination, determine the structure control sectional bending moment, shearing force and ax force design value. Finally, according to already calculate structure control sectional internal force value, the beam, slab and columns, the foundation being reinforced, and the mapping of the corresponding structure construction plan. At the same time, we used the software PKPM to ensure the reliability of results, and achieve the purpose of analysis, contrast the result which was calculated by ; internal force; reinforcement; control section 目 录 前 言·········· ···························1 第 1 章 设计资料 ·········· ······· ············2 1.1 工程概况 ············ ······· ············2 1.2 设计标高 ············ ······· ············2 1.3 气象资料 ············ ······· ············2 1.4 工程地质资料 ·····························2 1.5 抗震烈度 ············ ······· ············2 1.6 墙身做法 ············ ······· ············2 1.7 门窗做法 ············ ······· ············2 1.8 所用材料 ············ ······· ············2 第 2 章 结构布置和计算简图 ·························3 第 3 章 荷载计算 ·········· ······· ············5 3.1 恒载计算 ············ ······· ············屋面框架梁线荷载标准值 · ·············· ····5 3.1.2 楼面框架梁线荷载标准值 · ·············· ····5 3.1.3 屋面框架节点集中荷