RepRap开源3D打印机kossel mini固件解析及下载.docxVIP

RepRap 开源 3D 打印机kossel mini固件解析及下载 #ifndef CONFIGURATION_H #define CONFIGURATION_H // Thisconfiguratiofnilecontainsthe basicsettings.本//文件只包含基本配置 // Advanced settings can be found in Configuration高_a级dv配.h置//需要到 Configuration_adv文.h件中配置 // BASIC SETTINGS: select your board type, temperature sensor type, axis scaling, and endstop configuration 基本设置：选择板子类型，温度传感器类型，轴比率，限位开关设置 //============================================================ =============== //============================= =============================== DELTA Printer //============================================================ =============== // For a Delta printer replace the configuration files with the files in th // example_configurations/delta directory. // // User-specifiveedrsioninfo ofthisbuild todisplay i[nPronterfacee,tc] terminal window during // startup.Implementationof an ideaby ProfBrainoto informuserthat any changes made to this // build by the user have been successfully uploaded into firmware. #define STRING_VERSION_CONFIG_H DATE  TIME // build date and time #define STRING_CONFIG_H_AUTHOR (athlon, D-force) // Who made the changes. 这里配置修改配置的作者 // SERIAL_PORT selects which serialport should be used for communication with the host. // This allows the connection of wirelessadapters (forinstance)to non-default port pins. // Serialport 0 isstilulsed by the Arduino bootloaderregardlessof this setting. #define SERIAL_PORT 0 //这里配置用于传输 Gcode 的串口号，默认使用串口 0 作为通讯串口， 如果想要在其它串口用蓝牙通讯，可以配置为相应的串口号。 // This determines the communication speed of the printer // This determines the communication speed of the printer //#define BAUDRATE 250000 #define BAUDRATE 115200 //波特率配置，这里的波特率需要跟上位机一致才可以，否则将无法通讯成功 // This enables the serial port associated to the Bluetooth interface //#define BTENABLED // Enable BT interface on AT90USB devices //只适用于 AT90USB 相应的板子 //// The following define selects which electronics board you have. Please choose the one that matches your setup // 10 = Gen7 custom (Alfons3 Version)