astmd149美标标准固体绝缘材料电压击穿的实验方法.pdfVIP

v1.0 可编辑可修改 ASTMD149美标标准固体绝缘材料电压击穿的实验方法 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies 固体电绝缘材料在工业用电频率下的电压击穿和介电强度的实验 方法 1. Scope* This test method covers procedures for the determinationof dielectric strength of solid insulating materials atcommercial power frequencies, under specified ,3 Unless otherwise specified, the tests shall be made at 60Hz. However, this test method is suitable for use at anyfrequency from 25 to 800 Hz. At frequencies above 800 Hz,dielectric heating is a potential problem. This test method is intended to be used in conjunction with any ASTM standard or other document that refers to this test method. References to this document need to specify the particular options to be used (see . It is suitable for use at various temperatures, and in any suitable gaseous or liquid surrounding medium. This test method is not intended for measuring the dielectric strength of materials that are fluid under the conditions of test. This test method is not intended for use in determining intrinsic dielectric strength,direct-voltage dielectric strength,or thermal failure under electrical stress (see Test MethodD3151). This test method is most commonly used to determine the dielectric breakdown voltage through the thickness of a test specimen (puncture). It is also suitable for use to determine dielectric breakdown voltage along the interface between a solid specimen and a gaseous or liquid surrounding medium (flashover). With the addition of instructions 1 v1.0 可编辑可修改 modifying Section 12, this test method is also suitable for use for proof testing. This test method is similarto IEC Publication 243-1. All procedures in this method are included in IEC 243-1. Differences b