1602+ADC0808Proteus仿真(带图-程序).docVIP

1602+ADC0808Proteus仿真(带图-程序) 1602+ADC0808Proteus仿真(带图-程序) PAGE 1602+ADC0808Proteus仿真(带图-程序) 信号源参数设置（U2） （程序） #include #define uchar unsigned char #define uint unsigned int sbit oe=P2^0; sbit eoc=P2^1; sbit st=P2^2; sbit ale=P2^6; sbit rs=P2^4; sbit re=P2^5; uchar tab[]={0,.,0,0}; uint getdata; void delay(uint x) { uint a,b; for(a=x;a0;a--) for(b=110;b0;b--); } void wzhiling(uchar zhiling) { rs=0; re=0; delay(1); P0=zhiling; delay(2); re=1; delay(2); re=0; } void wshuju(uchar shuju) { rs=1; re=0; delay(2); P0=shuju; delay(2); re=1; delay(2); re=0; } void INIT() { wzhiling(0x38); delay(1); wzhiling(0x0c); delay(1); wzhiling(0x06); delay(1); wzhiling(0x01); delay(1); } void main() { uchar num=0; INIT(); while(1) { P3=0x00; ale=1; st=0; //此三条为启动程序 st=1; st=0; while(!eoc); // 等待转换完毕的信号，eoc=1是转换完毕； oe=1; //输出三态门打开，将转换的结果输出到数据总线上 getdata=P1; oe=0; getdata=getdata*100/51; tab[0]=0x30+getdata/100; tab[2]=0x30+getdata%100/10; tab[3]=0x30+getdata%10; for(num=0;num4;num++) { wzhiling(0x80+0x00+num); wshuju(tab[num]); } } }