泥炮开口机参考.docx

TOC \o 1-5 \h \z Appe ndix 1 ■ Equipme nt Specificati on and I Scope?of?Supply I 附件1 I 设备规格及供货范围 I TAPHOLE DRILLS AND VALVE STANDS FOR 3200 M3 BLAST FURNACE 开口机及其阀台用于 3200M 3高炉 TANGSHAN IRON STEEL CO. 唐山钢铁股份有限公司 prepared by: TMT -Tapp in g-Measuri ng-Tech no logy GmbH Hage ner Strasse 103 57072 SiegenGerma ny CONTENT GENERAL DESCRIPTION PROJECT DETAILS BASIC CONCEPT SPECIFICATION OF EQUIPMENT HYDRAULIC TMT TAPHOLE DRILLS Gen eral Descripti on of Taphole Drills Technical Data SPECIFICATION CENTRAL HYDRAULIC SYSTEM 2 2 1 General Description of the Central Hydraulic System Specification ELECTRIC AND INSTRUMENTATION General Description of Electrics and Instrumentation CIVIL WORKS Civil Engineering Foundation Metal Foundation Bolts PAINTING Equipme nt on the Cast House Floor Equipme nt in the Hydraulic Room and in the Con trol Houses ENGINEERING EXCLUSIONS FROM SCOPE OF SUPPLY DRAWINGS OF SPECIFICATION APPROVAL DRAWING LIST DIVISION OF SCOPE OF SUPPLY LIST 目录 总体概述 项目细节 基本概念 设备规格 液压开口机 开口机总体描述 技术数据 规格 中央液压系统 中央液压系统总体描述 规格 电气仪表 电气仪表的基本描述 土建工程 土建工程 基础金属 基础螺栓 油漆 出铁场地面设备 液压设备和出铁场内设备 2.6 工程 2.7 供货不包括项 2.8 规范图纸....... 2.9 图纸清单....... 供货范围分交表 1. GENERAL DESCRIPTION 总体概述 1.1 PROJECT DETAILS 1.2 1.2 0.3 MPa 0.5 -0.55 MPa 96% 9,288t/d ( max 10,095 t/d ) ~12 times 5.8 t/min ~134 mi n. 1450 -1550 ° 14 mi n. 3.200立方米 2.3-2.5吨/(天，立方 20年 0.3 Mpa 0.5-0.55 MPa 96% 9,288t/d ~12次 5.8吨/分钟 ~134 mi n. 14分钟 1450-1550° C 项目细节 Project Name The equipment of Taphole Drills, and its Hydraulic valve stands for the 3200 m3 Blast Furnace in Tangshan south area small Blast Furnace relocation modify project. 项目名称 用于唐钢南区小高炉易地技术改造工程的炉前开铁口机及其液压阀台 ? Blast Furn ace Tech ni cal Parameters ? blast furnace volume 3,200 m3 ? annual average utilization coefficient 2.3t /(d ? m3)max 2.5t (d ? m3) ? blast furn ace campaig n without in termediate repair 20 years ? furnace top pressure ? max. blast pressure ? annual average operating rate ? Daily out