压力表安装操作和维护(英文：PRESSURE GAUGE INSTALLATION OPERATION AND MAINTENANCE).docxVIP

— PAGE \* Arabic 1 — 压力表安装操作和维护(英文：PRESSURE GAUGE INSTALLATION OPERATION AND MAINTENANCE) PRESSURE GAUGE INSTALLATION, OPERATION AND MAINTENANCE   1.0 SELECTION (b) contain heavy particulates (slurries) or (c) are very viscous including those that harden at room temperature.  1.4 Oxidizing media– Gauges for direct use on oxidizing media should be specially cleaned. Gauges for oxygen ser-vice should be ordered to variation X6B and will carry the ASME required dial marking “USE NO OIL” in red letters. Gauges for direct use on other oxidizing media may be ordered to variation X6W. They will be cleaned but carry no dial marking. PLUS!?Performance gauges or Halocarbon filled gauge or diaphragm fill is required for use with oxidiz-ing media; order variation XCF.  1.5 Pulsation/Vibration– Pressure pulsation can be damp-ened by several mechanisms; the patented PLUS! Perfor-mance gauge will handle the vast majority of applications. One exception to this is high frequency pulsation which is difficult to detect. The only indication may be an upscale zero shift due to movement wear. These applications should be addressed with a liquid filled gauge, or in extreme cases, a remotely mounted liquid filled gauge connected with a length of capillary line. The small diameter of the capillary provides excellent dampening, but can be plugged. The Ashcroft 1106 pulsation dampener and 1112 snubber are auxiliary devices which dampen pulsation with less tendency to plug.  1.6 Gauge fills. – Once it has been determined that a liquid filled gauge is in order, the next step is selecting the type of fill.Glycerin satisfies most applications. While being the least expensive fill, its usable temperature range is 20/180°F. Silicone filled gauges have a broader service range:  –40/250°F. Oxidizing media require the use of Halocarbon, with a service range of –40/250°F. Pointer motion will be slowed at the low end of the low end of these temperature ranges.  1.7 M