标称塑性力矩全复合作用.pdfVIP

第一章 标称塑性力矩 全复合作用 第二章 Nominal Plastic Moment: Full Composite Action The design flexural strength of a fully composite section is determined per ANSI/AISC 360-10 I3.2. During the design it is assumed that the nominal moment strength of the section can be calculated based on the plastic stress distribution on the composite section for the limit state of yielding (that is, the plastic moment). This assumption is valid for all standard W shapes in the AISC manual with F y 50 ksi. The plastic stress distribution assumes that the steel is fully yielded (in compression or tension) and that the concrete stresses can be represented by an equivalent uniform stress block of intensity 0.85f c There are generally two categories of solutions: the first in which the Plastic Neutral Axis (P.N.A.) falls within the concrete slab and the second in which the P.N.A. is in the steel section. 第三章 Plastic Neutral Axis in Concrete The location of the P.N.A. is determined by first assuming that it falls in the concrete slab and then trying to calculate the depth of the equivalent concrete compressive stress block. If the P.N.A. falls within the slab, all of the steel section must have yielded first, and so the compressive force in the concrete stress block can be equated to the total tension in the steel: where b e is the effective width of the concrete flange, A s is the cross-sectional area of the steel section, and a is the depth of the compressive stress block. By solving for a, the location of the P.N.A. (if a ￡ t s ) can be found, or the P.N.A. can be determined to be in the steel section (if a t s ); an invalid condition because it would require more concrete than is available to balance the full tension in the steel). If the location of the P.N.A. is confirmed to be within the concrete slab, then the nominal moment capacity of the composite section can be found by adding the momen