美国球阀厂家说明-31.pdf

Installation, Operation Maintenance Instructions ROTARY 1/4 TURN A TUATOR / DOUBLE A TING SPRING RETURN MODELS Suitable for use in safe area and hazardous gas/dust atmospheres (ATEX) A TUATOR SEAL REPLA EMENT INSTRU TIONS 1. DISMANTLING A TUATOR (see exploded drawing/parts Vane sub assembly with hex head bolts list) CAUTION: Before dismantling, check there are no burrs 2.10 Fit Side plate Infill Insert into Side plates (07 only) Push hex on square drive shafts. If there are, remove to avoid damage headed bolts with plain washer through side plate. to bearings and shaft seals during removal of case halves. In 2.11 Apply low strength anaerobic adhesive to bolt holes, then the case of spring return actuators, remove spring unit assemble seal, expander and sideplate to vane. (according to following section) before opening actuator case. 2.12 Screw bolts down and tighten to torques given below. FOR DISMANTLING/RE-ASSEMBLY INSTRUCTIONS FOR 2.13 Turn vane over then fit seal, expander and side plate over 20/30 SIZE ACTUATOR REFER TO KINETROL TECHNICAL end of bolts. Check orientation as before. DATA SHEET TD104. 2.14 Screw nuts down thread. 1.1 All models: loosen, but do not remove, all case screws. 2.15 Position vane assembly in coupling on bench, hold head of 1.2 Separate case halves by connecting air line to inlet port