美国球阀厂家说明-27.pdf

Title: Installation, Operation Maintenance Instructions - 20 30 Double Acting Spring Return Actuators SPRING REMOVAL/REPLACEMENT INSTRUCTIONS FOR 20 30 SPRING RETURN ACTUATORS. 5. Removal of Spring Pack Warning: The wound-up springs store a large amount of energy which, if suddenly released, can be dangerous. 5.1 Securely support actuator/spring unit in a vertical position by use of a bracket which is connected to the actuator mounting flange. This bracket will either need to be fixed to the floor or have a large stable base. 5.2 A keeper plate strong enough to take the full torque must be fitted in order to remove S/R pack without spring tension. Refer to table on page 5 of TD 129. 5.3 Connect airline via a pressure regulating valve to actuator air inlet 5.4 Place the keeper plate over square shaft protruding from S/R pack. 5.5 Increase air pressure slowly until actuator vane turns to mid-travel position. Keeper plate holes will then line up with threaded holes in spring housing. 5.6 Insert four bolts through keeper plate holes and tighten to lock keeper plate in position and disconnect air supply. 5.7 Fit two lifting eyes to keeper plate and connect to suitable lifting equipment to later lift the spring pack from the actuator. 5.8 Remove four lower retaining screws which retain the spring pack to the spring pack base. 5.9 Slowly lift the spring pack vertically from the actuator ensuring that the actuator does not lift as well and that lower spring coupling moves with the spring pack. 5.10 Remove baseplate fixing screws, baseplate gasket/o-ring and clean parts. 5.11 Lower the spring pack on its side and fit a baseplate to the underside of the spring pack or lowe vertically onto the baseplate. Seal with plastic film to protect the springs during storage/shipment. 5.12 In th