美国球阀厂家说明-28.pdf

Title: Installation, Operation Maintenance Instructions - 20 30 Double Acting Spring Return Actuators Figure 4 4 OFF M30 (METRIC) M16 LIFTING HOLES (2 OFF) OR 1 1/8 UNC (ANSI) KEEPER PLATE FIXING SCREWS SPRING COUPLING INTERMEDIATE SPRING HOUSING BASE PLATE O-RING SEAL BASEPLATE BASEPLATE FIXING GASKET o O-RING SCREW 7 Spring pack integrity check for 20 30 spring return actuators. 7.1 To check the integrity of a 20 or 30 spring return actuator, the actuator must first be removed from the valve so that all external loads are removed. 7.2 Connect an airline via a pressure regulating valve to the air inlet port (minimum of 3/8 air ports to be used). 7.3 Fit an indicator to the top of the spring pack shaft (e.g. a length of weld wire) so that small movements of shaft can be detected. 7.4 Increase the air pressure to the actuator gradually until the pointer can be seen to move and record the setting. Note: ensure that the leakage from the actuator is not excessive and the pressure change is very gradual otherwise a false reading may be obtained. The reading must always be taken as a rising signal. 7.5 The setting should be higher than: