磨合表面的测量与分析.docVIP

磨合表面的测量与分析 　　摘　要：基于对磨合前、后发动机缸套表面形貌的测量，给出了发动机缸套表面形貌的偏态、峰态、平均波长、平均斜率等参数的设计要求。从磨损深度和磨损体积两方面对磨合磨损量进行了分析，并指出了两者间的区别。 　　关键词：表面形貌　缸套　磨合 Measurement and Analysis of Running-in Surfaces Liu Xiaojun 　　Abstract:Based on the measurement of the surface topograph y of cylinder bore before and after running-in, the design requirements of the surface topography parameters of cylinder bore are given in terms of skewness, kurtosis, average wavelength and the rms slope, et al. The running-in wear is analyzed by using two concepts of radial wear and wear volume, and the difference between the two concepts is poin