电源模块3ps465.9 最详细说明书.pdfVIP

BR 2005 Modules • Power Supply Modules • General Information 3. Power Supply Modules 3.1 General Information Power supply modules create the voltages required internally by the PLC from a 24 VDC input voltage. Each main and expansion unit requires its own power supply module. The power supply module always has to be operated in the far left slot of the backplane. All power supply modules require two slots. 3.1.1 Overview Power Supply Input Voltage Output Power Interface for System Expansions PS465 Max. 60 W Expansion slot 24 VDC PS477 Max. 58.5 W Expansion slave Table 30: Power supply module overview 3.1.2 Slots The power supply must always be located on the far left slot. When configuring a system, make sure that the power consumption of all modules installed is not larger than the output power of the power supply module. If a power supply unit cannot provide the power required by the modules, install the I/O modules on an expansion backplane. 3.1.3 Current Limitation Power supply modules are equipped with an internal current limit (short circuit protection) and have connections for an external buffer voltage (AC240 battery module). The current limitation is also activated if the modules require more power than the power supply can deliver. This causes a reset on the CPU without a power failure having occurred. 94 BR SYSTEM 2005 Users Manual V4.0 BR 2005 Modules • Power Supply Modules • General Information 3.1.4 10-pin Terminal Block Connection Assignment