RS Components 其他网络设备 MOSFET 驱动器 FZL4146GGEGXT 使用说明.pdfVIP

Quad Driver Incl. Short-Circuit Signaling FZL 4146 Bipolar IC Features Short-circuit signaling Four driver circuits for driving power transistors Turn-ON threshold setting from 1.5 to 7 V P-DSO-20-7 Type Ordering Code Package FZL 4146 G Q67000-H8743 P-DSO-20-7 (SMD) General Description The IC comprises four driver circuits capable of driving power transistors (PNP or PMOS). The output transistors are protected against short-circuit to ground and supply voltage. The turn-ON threshold can be set from 1.5 V to 7 V. Overload at one or several outputs will be indicated at pin SQ (signaling output). The corresponding power transistors are then protected by changeover to clock-governed operation. Circuit Description Each driver circuit has one active high driver input Dl and a common enable input ENA (active high) is provided for all stages. The Q output is designed to drive the output transistors. The load current is sampled and, if necessary, limited via pin W. If the load current exceeds the preset value, the output stage switches off. Switching-ON again is provided by the built-in clock generator T. Its operation requires an external capacitor Ce at pin CE. If C is bridged by a break-key, switching-ON can only be carried out by e operating this key. The duty cycle of the clock generator is 1:47 (e.g. 45 µs/2.1 ms with Ce = 10 nF). The clock generator is privileged versus the current sensor shut down. When the supply is connected, the internal RS-FF goes into the state corresponding to the released output. Semiconductor Group 1 03.96