RoboMaster C620无刷电机调速器使用说明（中英日）V1.01.pdfVIP

C620 Brushless DC Motor Speed Controller User Guide 使用说明 ユーザーガイド V1.0 2017.09 Disclaimer Thank you for purchasing the RoboMaster C620 Brushless DC Motor Speed Controller (hereinafter referred to as “product”). Read this disclaimer carefully before using this product. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. Install and use this product in strict accordance with the User Guide. SZ DJI TECHNOLOGY CO., LTD. and its affiliated companies assume no liability for damage(s) or injuries incurred directly or indirectly from using, installing or modifying this product improperly, including but not limited to using non-designated accessories. DJITM is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its affiliated companies. Names of products, brands, etc., appearing in this document are trademarks or registered trademarks of their respective owner companies. This product and document are copyrighted by DJI with all rights reserved. No part of this product or document shall be reproduced in any form without the prior written consent or authorization of DJI. The final interpretation rights of this disclaimer is owned by DJI. Warning 1. Make sure that there are no short circuits and all the cables are correctly connected when using the speed controller. 2 2. The speed controller will heat when the output power is too high. Please handle carefully to avoid scalding. 3. Ensure that all parts are in good condition. Replace them when necessary. 4. The input signal mode (PWM signal or CAN bus communication) cannot be changed while the product is in use. Power off the product to set the signal mode and restart to apply a new mode. 5. Be sure to use the product in strict accordance with the specifications (vol