教程5.13g加密所属官方plate.pptxVIP

WORKSHOP 16 STIFFENED PLATE;Workshop Objectives Create a model of a plate with two types of stiffeners. For one type of stiffener, the arbitrary beam section calculator in Patran will be used to obtain the cross-section properties. For the other type of stiffener, the Patran standard beam Library will be used to obtain the cross-section properties. The model is finished, i.e. create constraints and pressure loading. An analysis of the model is performed, and the results viewed using MD Nastran and Patran. Problem Description Show the stress for the plate or beam elements on the deformed shape of the model All material: Aluminum with E = 10 x 106 psi and n = 0.3 Pressure on piston = 5 psi Software Version Patran v2008r1 MSC Nastran 2008r1 ;Key Concepts and Steps Database: create a new database with Analysis Code = MD Nastran and Analysis Type = Structural Geometry: create the surfaces that are to represent the plate Elements: mesh the surfaces with plate elements, and mesh select edges of the surfaces with bar elements Loads/BCs: apply a simply supported constraint on two opposing edges of the plate, and apply a pressure to the surface of the plate Materials: specify an isotropic material for Aluminum Properties: create a 2D plate property for the plate, and a 1D beam property for each of the two types of stiffeners Analysis: Solution Type = Nastran Linear Static, Solution Sequence = 101, Method = Full Run Analysis: access analysis results by attaching the XDB file to database Results: plot von Mises stress for plate elements, bar stress for bar elements, and displacement results for each;Create New Database;Step 1. Geometry: Create / Surface / XYZ;;Step 2. Geometry: Edit / Surface / Break;;;Step 3. Finite Elements: Create / Mesh / Curve (Cont.);Step 4. Finite Element: Equivalence / All / Tolerance Cube;Step 5. Material: Create / Isotropic / Manual Input;Step 6. Element Properties: Create / 2D / Shell;Step 6. Element Properties: Create / 2D / Shell (Cont.);Step 7.