太阳眼镜的3D建模-FreeForm Modeling Plus软件教程.pdfVIP

SensAble Technologies Inc. FreeForm Shades Dem Workflow_rev3 Rev. 2 SHADES DEMO WORKFLOW The following document describes the design and modeling workflow of a set of sunglasses using a selection of tools in FreeForm Modeling Plus (this demo may also be able to be done in Concept, replacing the use of the Deform tool with the use of the Tug tool). SensAble Technologies, Inc. Page 1 © 2004 SensAble Technologies, Inc. All rights reserved. 3D Touch, FreeForm, FreeForm Concept, FreeForm Modeling, FreeForm Modeling Plus, FreeForm Mold, GHOST, HapticSound, OpenHaptics, PHANTOM, PHANTOM Desktop, PHANTOM Omni, SensAble, SensAble Technologies, Inc., Splodge, Splodge design, and WebTouch are trademarks or registered trademarks of SensAble Technologies, Inc. Other brand and product names are trademarks of their respec tive holders. Page 1 of 10 SensAble Technologies Inc. FreeForm Shades Dem Workflow_rev3 Rev. 2 Use sketch planes to design front, side and top elevation views. Use the line tool in the sketching environment to layout dimensions for the overall height and width etc… These help to develop the spline curves. Use wire-cut with the top plane to produce a blank piece of clay. Use the deform tool to crown the front profile of the glasses, pushing the lower front rail towards the back. SensAble Technologies, Inc. Page 2 © 2004 SensAble Technologies, Inc. All rights reserved. 3D Touch, FreeForm, FreeForm Concept, FreeForm Modeling, FreeForm Modeling Plus, FreeForm Mold, GHOST, HapticSound, OpenHaptics, PHANTOM, PH