喷气式飞机BD5 制作指南.docx

Designed and Drawn by: Tony Audsley (Lockey) Suggested build specs: Material: 6mm Depron or MPF (approx one and a half full sheets) 1000 x 700 sheet Servo’s: 3 x HXT900 9g (or similar) Motor: D2826-6 2200kv Outrunner Motor (or similar) ESC: TURNIGY Plush 40amp Speed Controller (or similar) Prop: GS Sport 6x4E Precision propeller (or similar) These are the formers shown in the position they need to go The Fuselage Skeleton First glue F8 and F9 in place on the “vertical former” Glue the “horizontal former” to the “vertical former” and into F8 Glue the ’’top formers” in place … as shown Please no