SunNuclear三维水箱特点.pptVIP

自动调节水平 Auto leveling takes three water measurements to determine the leveling required 自动调节水平 计算机会自动计算出需要水平水箱需要调节的角度 自动寻找Beam Center 3DS可以通过扫描数据来确定Beam Center. 调节水箱中心 Movement (±) 30 mm 确定Beam center之后，计算机会控制电动平台在X，Y轴的方向平移。使水箱中心与Beam center重合 自动摆位（Auto Setup）带来的好处 Auto Setup 可以将水箱的摆位时间从1~2个小时缩短至10~20分钟。 Auto Setup的过程仅仅需要操作人员点击鼠标，以及操作加速器 避免人员的因素导致的测量的差异性。自动摆位重复性更高。 * * * * * * Advantages of a 3D Cylindrical Water Scanner Max Tang Medical Physicist Outline TG – 106介绍以及数据采集 常见问题 3DS 水箱特点 圆筒状箱体设计 AutoSetup 自动摆位功能 TG-106 This task group was formed to review the physics of commissioning linear accelerators and to provide guidelines and recommendations on proper selection of detector, phantom, and methods to reduce measurement errors below ±1% in beam data acquisition. AAPM Task Group 106 “Accelerator beam data commissioning equipment and procedures: Report of the TG-106 of the Therapy Physics Committee of the AAPM,” Med Phys 35 (9): 4186-4215, Sept 2008. TG-106 III.B. Scanning water tank III.B.1. Positioning and labeling III.B.2. Scanner movement III.B.3. Orientation III.C. Scan mechanism and movement III.C.1. Array detector weight III.C.2. Speed and position accuracy III.C.3. Hysteresis III.C.4. Corrosion III.E. Data acquisition III.E.1. Scanning parameter protocol III.E.2. Speed III.E.3. Delay time III.E.4. Sampling time and signal III.E.5. Radio frequency noise interference 足够大的扫描范围: Diagonal profiles of 40x40 cm2 with lateral buildup 5cm over scans. Suggested 75x75 cm2 in transverse size. The half field scan be extended 5 cm past the central axis. 相对较小体积的探头: Ion chambers with small volumes are generally preferred. Ref. detector shall be used for removing the instantaneous fluctuations or drifts in the incident beam output. 稳定的扫描结果: The chamber shall scan with the least amount of moving parts; Orient the detector mount so that it provides the highest resolution. Precautions: “Do not scan in the axial direction of the detector.” Adjust the ste