EM100 200 CCD Camera 使用手册说明书.pdf

III. Installation Instructions Decide the location to install the metal case camera. The horizontal 4) Wall Mount, aim to left: Remove the metal case from the supporting bracket view angle of the metal case camera with 3.6 mm lens is 92-degree. by using screw driver to loosen the two screws, which In application, the metal case camera can be installed as the connect the iron case to the supporting bracket. Turn following four positions : the metal case in 90-degree and mount into the supporting 1) Ceiling mount bracket again by changing the screw holes in order to keep 2) Floor mount the screw indicator on the bottom side. 3) Wall mount, aim to right Note: Before installing, please make sure the washer is at its 4) Wall mount, aim to left original position, or PCB may be damaged. (Please refer to the diagram shows below) In order to get the correct picture, please always keep the cable connector on the bottom side. 1) Ceiling Mount : The metal case camera are set in the actual po