Agilent High-Pressure Injection Device for the Agilent 7890A and 6890 Series Gas Chromatographs 说明书用户手册.PDF

High-Pressure Injection Device for the Agilent 7890A and 6890 Series Gas Chromatographs Accessory G3505A Introduction • EPC: An auxiliary flow from a 7890A Aux module is connected to port P. In sample Gas chromatography sampling and representative analysis, the flow can be set at 50 mL/min to analysis of highly volatile liquefied hydrocarbons 200 mL/min. The higher auxiliary flow gives with high precision and accuracy can be challeng- better peak shape. ing. In the solution described here, a unique sample injection device based on a needle interface and Ordering Information liquid rotary valve, has been designed for sampling light petroleum matrices with broad boiling point Order accessory G3505A. The accessory is compat- distributions. The 7890A GC-based system consists ible with both the 7890A and 6890 series GCs. of a 4-port liquid valve, a deactivated removable needle, and an auxiliary flow. The needle is directly The following components are recommended. installed on one port of the valve. This compact These are not supplied in the accessory kit. device is installed directly over the top of a • Filter: To remove particles from samples. split/splitless inlet. The unit is operated automati- cally just like a typical liquid autosampler; however, • Restrictor: To maintain sample pressure, a the needle is not withdrawn. Various pressurized metering valve (Agilent PN 101-0355) is con- liquid samples have been run on this device, such nected to the end of the sample exit line tubing. as liquefied natural gas (calibration standard)