英文安装图新君威3300c图.pdfVIP

3300 Series Installation Instructions for Regal OBD 插头位于驾驶员位置脚踏板上，将OBD 插头拆下，与系统线束串联起来。 The OBD socket is above the brake pedal of the driver ’s seat. Dismantle the OBD socket and connect it with the OBD connector and wire harness of the system. 注：根据不同车型，线颜色会有变化，按位置先测量正确再接上产品线：The color of the wire will differ for different m s of cars. Please test the wire according to the ition of it to make sure it is correct and then connect it to the wire of the system. 位于方向盘下方BCM 灰色插头：On the grey plug located under the steering wheel. 开锁负棕白：Brown/White-Unlock (-) 关锁负棕黄：Brown/Yellow-Lock (-) 位于方向盘上方：Located he upp art inside the guard panel of the steering wheel 喇叭线：Horn Wire 针对一些需要拔6 号键车型……：For some m s of cars which need to pull down the SW6, or the car audio of them will only be turned o y connecting the auxiliary wire otherwise the car audio can only be turned o y opening the door. 位于主门内升窗电机下方：Under the er window motor of driver ’s door 门边线灰色：Grey-Door trigger 辅助线（黄色）Yellow-Auxiliary Wire 点火按键：Ignition Button 3V 电压：3V Voltage 1mm 处切断：1mm cut off 数据检测线：Data detecting wire 搭铁线 黑色（必须接）Black-GND (Must be connected) 开锁线：Unlock Wire 上锁线：Lock Wire 搭铁线 黑色（必须接）Black-GND (Must be connected) 喇叭线 粉红色：Pink -Car Horn 对码开关：Remote Control C earning Sw. 对码方法：Remote Control Learning Pro s: Press and hold the learning switch for 5 sec, the horn will chirp once, the turn signal lights will light solid. Press any button of the remote control to be learn this time, the horn will chirp once, indicating suc sful learning. 点火按键安装效果图：Effect picture of the ignition button after installation 拔码开关的调整： Settings of Dip Switches: SW 1: Down-Silent Mode, the horn will not chirp when locking/arming, disarming and remote engine start. SW2: Up-Automatic Transmis