EMERSON艾默生 Manuals AMAL IR Series (Removable Element) Flame Arresters IOM (ES 0 0 132), Anderson Greenwood-EN说明书用户手册.pdf

ANDERSON GREENWOOD AMAL IR SERIES (REMOVABLE ELEMENT) FLAME ARRESTERS INSTALLATION MAINTENANCE INSTRUCTIONS Includes: IRF, IRD, IRDB, IRQ IRQS types and eccentric variants (E) 1. GENERAL 10. If the normal operating or atmospheric 2.2 Screwed connection (DN 80 or 3 NPS temperature can cause freezing within the and smaller) - fit to the corresponding IR Series flame arresters are intended for use flame arrester, it is advisable to provide male/female threads. Sealing tape or in piping systems handling flammable gases/ trace heating to the flame arrester element sealant may be used to ensure a good vapors. and housings - if electrical this must be seal. in accordance with EN500018:2000. It is 3. Ensure that any accessory nozzles are fitted 2. GUIDANCE important to ensure that the flame arrester with the necessary accessories or with unit is ATEX certified for use at the elevated plugs/blanking flanges as appropriate. 1. Maximum temperature limits -20° to +60°C temperature of the process fluid, created by 4. When appropriate, it is recommended that covering the general range of flame arresters the external heating source. a protective cage be installed to guard the (see special conditions for safe use). 11.Where a dedicated heating jacket (steam or flame arrester against accidental impact 2. IR series detonation or deflagration type hot fluids) is supplied as part of the flame from vehicles or from heavy falling objects. flame arreste