Danfoss丹佛斯Series 20 MF Manifold Kit Instructions 安装指南.pdf

Service Kit Instructions Series 20 Manifold replacement procedure Manifold assembly kit Quantity Description 1 Manifold assembly 2 O-rings 1 O-ring 6 Bolts 6 Washers 1 Orifice plug A. Removal 1. Prior to removal of manifold assembly, remove all dirt, and clean area where manifold assembly is attached to end cap. 2. Place drain pan under manifold to catch oil. Figure N 3. Remove the four (4) corner bolts holding manifold to motor end cap. See figure N. 4. Grasp manifold to prevent it form dropping and