ABYC E-01 - Bonding of Direct Current Systems 直流系统的连接.pdf

E-I (8) 5--30-72 BONDING OF DIRECT CURRENT SYSTEMS PROJECT E-1 (ADOPTED WITH PROPOSED REVISIONS MAY 30, 1972) E-I-72 E-1.1. PURPOSE This standard establishes requirements and recommended methods for bonding direct-current electrical systems: - to provide a low-resistance electrical path, within the confines of the hull, between otherwise isolated metallic objects, particularly those in common contact with sea water and potentially subject to electrolytic corrosion due to stray currents; to prevent the possible existence of an electrical potential on exposed metallic enclosures of electrical equipment; - to provide a low resistance path to ground for voltages that may be considerably in excess of those for which the system is designed, as might occur when lightning strikes, and - to minimize radio interference. E-1.2. SCOPE This standard applies to all boats equipped with direct-current electrical systems operating below 50 volts. E-1..'J. DEFINITIONS a. Ground - A surface or mass at the potential of the earth's surface, established at this potential by a conducting connection (intentional or accidental) with the earth, including any metal mea which forms part of the wetted surface of the hulL b. Bonding T