拉断阀结构图.pdf

OM MANUAL - HOSE LOADING STATION DOC.NO: 170073-R-TA011-MB02-0104 Rev: 0 Date: 15.11.06 Prepared by: A. Thompson Breakaway Coupling Make-Up Procedure The Valved-Breakaway coupling comprises of two halves – “male” and “female” as shown in the diagram. For operation the coupling halves are assembled and held together using 3 off threaded/reduced diameter studs. The coupling is normally supplied in the assembled condition. In the event of having to change the studs for maintenance or after a break, the following procedure should be followed: 1. Ensure the faces and sealing surfaces of the male and female bodies are clean 2. Check that the O-ring is sound, unmarked and free from debris 3. Ensure the threaded holes in the female body are clear and clean 4. The male body is then aligned with the female body, where the noses of each internal probe are in contact. The two halves are then drawn together using three temporary standard bolts – ensure that this is done evenly by rotating each of the three bolts repeatedly in turn and keeping the coupling halves aligned. The coupling is fully assembled when the mating faces touch and no gap is visible between the two halves. 1 Page 165 of 217