EN 认证程序介绍.pptx

会计学1EN 认证程序介绍 Bureau Veritas Presentation2BUREAU VERITASEN1090-1 certificating procedure一、Requirements and Evaluation methods 认证要素要求及评估方法 Constituent products 构件产品Requirement要求（4.1）Constituent products for steel components shall be in accordance with the European Standards referred to in the relevant Clauses of EN 1090-2.用于钢部件的构件产品应与EN1090-2相关章节引用标准一致Evaluation methods评估方法（5.2）The constituent products shall be evaluated by checking that the inspection documents for the products used comply with the requirements of the component specification.The evaluation of constituent products shall also include a check that the geometry of the products is correct, using methods and instruments in accordance with 5.3.构件产品通过检查根据部件规范进行检验的资料和几何尺寸测量来评估第1页/共65页 Bureau Veritas Presentation2BUREAU VERITASEN1090-1 certificating procedure2. Tolerances on dimensions and shape 尺寸及形状公差Requirement要求（4.2） The geometrical tolerances specified in EN 1090-2 for the essential tolerances shall apply to all components. If any special tolerances apply these shall be stated in the component specificationEN1090-2规定基本公差适用所有部件，如有特殊要求应在部件规范中注明Evaluation methods评估方法（5.3）Geometrical tolerances shall be measured using methods and instruments selected from those listed in ISO 7976-1 and ISO 7976-2 and in accordance with provisions given in EN 1090-2. Accuracy of measurements shall be assessed in accordance with ISO 17123-1.几何公差应使用ISO7976-1、2中规定的方法、仪器按EN1090-2要求进行测量，测量精度应符合ISO17123-1规定第2页/共65页 Bureau Veritas Presentation2BUREAU VERITASEN1090-1 certificating procedure3. Weldability 焊接性Requirement要求（4.3） If steel structural components are to be declared as weldable they shall be made of weldable constituent products according to EN 1090-2 or EN 1999-1-1 as appropriate. If relevant to the performance of a steel product the through-thickness properties shall be declared.钢结构声明使用按EN1090-2或EN1999-1-1可焊的构件部件焊成，全厚度性能应提供Evaluation methods评估方法（5.4）For weld ability, reliance may be placed on properties a