Danfoss丹佛斯Medium duty piston pump model 70160-903 design 02 shimming process installation information 安装指南.pdf

Installation No. 04-622 Information July 1999 Introduction This shim kit is to replace the crush ring within the trunnion cover. If the camplate, trunnion cover or housing is replaced during servicing, the old Medium Duty Series crush ring can no longer be used to assure proper preload. ® Danfoss Pumps Shimming procedures: Kit 70160-903 1 Measure the thickness of the existing crush ring. 2 To obtain a starting point stack shims to the measurement of existing -02 Design crush ring. Then insert shims into the trunnion cover in the same location as the removed crush ring. Shimming 3 Assemble the housing sub-assembly consisting of the housing, camplate, bearings and trunnion covers. Install the trunnion cover bolts and torque to 56,9 N·m [42 lbf·ft]. Process 4 With a torque wrench, check the torque required to rotate the control shaft. The specied torque level is 2,26 ± 0,6 N·m [20± 5 lbf·in]. - If torque level is too low, add additional shims and repeat steps 3 and 4 unt