ABB Power Break® II Push Button Cover - GEH6282 说明(英语)用户手册.pdf

1 GEH6282 INSTRUCTIONS Power Break® II Circuit Breaker Accessories Push Button Cover Introduction Operation The Push Button Cover, shown in Figure 1, can Close the cover and put a sealing wire or wire tie be installed on 800-4000 ampere frame Power in the slot. Each of the covers may be sealed Break II circuit breakers. The catalog number is independently. SPPBCOVER. Installation It consists of two unbreakable, individually seal- able Lexan® shields, one over the PUSH ON button Mount the Push Button Cover with one thread and one over the PUSH OFF button. Sealing the cutting screw centered between the PUSH ON cover prevents accidental or unauthorized closing and PUSH OFF buttons. Either of the Lexan® or opening of the circuit breaker with the local shields can be removed. push buttons. Each shield also has a drill point near its center. If desired, remove the shield and drill a small (approximately 1/8-inch diameter) hole through the shield to create a limited-access push button cover similar to that offered on the original Power Break circuit break