汽车示波器使用技术指导执行器.docVIP

汽车示波器使用技术指导 执行器 汽车示波器使用技术指导 执行器 汽车示波器使用技术指导执行器2010-12-06 13:56汽车示波器软件操 作说明执行器 1、测试时如何连接示波器:博世CDi 3喷油嘴在PicoScope的通道A上插 入一个TA000测试头.连接这个低电流钳(0到60amps)到TA000测试头的4mm槽 上,如图57.1所示(如果使用早期型号的电流钳).在最新型号的成套工具中,电 流钳将直接插入通道A上.保证电流钳的开关打开并且它的9伏电池状况良好. 把这个低电流钳调整归零.图57.1连接低电流钳在共轨柴油机喷油器(CDi)控制 装置到喷油嘴的信号线上,如图57.2.图57.2 2、CDi喷油嘴示例波形3、CDi 喷油嘴波形注意点示例波形显示了引燃和主级喷射.轨迹将根据引擎负载和速度 变化.4、技术资料-CDi喷油嘴共轨柴油机喷射系统几乎是新柴油机汽车的一个 标准特征.The injector is mechanically similar to the direct injection type of injector which has been used for many years,but we no longer rely on fuel pressure tocrack offthe injector,and instead we electronically control the opening time and duration of the injector similar to apetrol injector.The CDi version 3system injector differs from the earlier topic within these help pages in the following ways: -Seven hole injector 1600 bar pressure Amore powerful electromagnet resulting in more rapid firing of the injector and lower current consumption5、发现并解决缺陷波形如果你怀疑这个信号的缺点,测试从CDi控 制单元到喷油嘴的接线.保证CDi控制单元has good power supplies and grounds whe re required by checking with the appropriate technical data.1、测试时如何连接到示波器:博世CDi压力调节阀在PicoScope的通道 A上插入BNC测试头.将黑色鳄鱼夹插在黑色表笔上(负极)and connect this to asuitable ground point.将绝缘尖探头插在红色表笔上(正极)in order to backpin the connector at the pressure regulation valve,如图55.1.If asuitable automotive break out lead is available,this may be used instead of the back pinning method.图55.1此阀有两个电气连接点:一个 点火正极(15)和一个开关地极.2、压力调节阀示例波形3、压力调节阀波形注 意点共轨柴油机喷射器(CDi)压力调节阀是一个执行器.It is commonly supplied with an ignition live(15)and aduty cycled ground,provided by the CDi control unit,that controls the pressure.4、技术资料-压力调节 阀Most common rail systems now employ apressure regulation valve.This can be located either on the high-pressure pump or on the common rail itself.The pressure regulation valve serves with the quantity control valve to control the common rail pressure.The pressure relief valve simply allows more or less high pressure fuel to flow into the back leak system thus inc