交换机基本操作(华为).pptxVIP

交换机基本操作第1页，共30页。交换机的初始启动系统启动例程会初始化交换机初始启动利用缺省配置参数1. 启动前确认正确连接线缆和控制线2. 接入电源3. 观察启动顺序面板上的指示灯LEDsCisco IOS输出到控制台上的内容第2页，共30页。检查交换机指示灯(LEDs)第3页，共30页。交换机自检期间的端口指示灯 1. 启动时，所有端口指示灯变绿.2. 每个端口自检完毕，对应的指示灯熄灭.3. 如果端口自检失败, 对应指示灯呈黄色.4. 如果有任何自检失败情况，系统指示灯呈现黄色.5. 如果没有自检失败, 自检过程完成.6. 随着自检过程的完成, 指示灯闪亮后熄灭.第4页，共30页。交换机初次启动时的显示信息Catalyst 1900 Management ConsoleCopyright (c) Cisco Systems, Inc. 1993-1998All rights reserved.Enterprise Edition SoftwareEthernet Address: 00-50-BD-73-E2-C0PCA Number: 73-3121-01PCA Serial Number: FAA0252A0QXModel Number: WS-C1924-ENSystem Serial Number: FAA0304S0U3Power Supply S/N: PHI025101F3-------------------------------------------------1 user(s) now active on Management Console. User Interface Menu [M] Menus [K] Command Line [I] IP ConfigurationEnter Selection: 控制台连接第5页，共30页。登入交换机并键入特权模式密码控制台用户模式提示 enableEnter password:## disable quit特权模式提示第6页，共30页。显示交换机初始启动的状态Switch#show versionSwitch#show running-configSwitch#show interfaces显示交换机的各种运行状态第7页，共30页。交换机之show version 命令wg_sw_c#show versionCisco Catalyst 1900/2820 Enterprise Edition SoftwareCopyright (c) Cisco Systems, Inc. 1993-1998wg_sw_c uptime is 15day(s) 21hour(s) 53minute(s) 11second(s) cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memoryHardware board revision is 5Upgrade Status: No upgrade currently in progress. Config File Status: No configuration upload/download is in progress 27 Fixed Ethernet/IEEE 802.3 interface(s)Base Ethernet Address: 00-50-BD-73-E2-C0第8页，共30页。交换机之show running-configuration 命令Catalyst 1924Catalyst 1912wg_sw_c#show runBuilding configuration...Current configuration:!hostname wg_sw_c!ipip!interface Ethernet 0/1text omittedinterface Ethernet 0/24!Interface Ethernet 0/25!interface FastEthernet 0/26!interface FastEthernet 0/27wg_sw_c#show runBuilding configuration...Current configuration:!hostname wg_sw_c!ipip!interface Ethernet 0/1text omittedinterface Ethernet 0/12!Interface Ethernet 0/25!interface FastEthernet 0/26!interface F