ASME A112.4.4-2017 塑料推配件排水、废弃物和通风(DWV)配件.pdf

Plastic Push-Fit Drain, !a~te, and Vent (DWV) Fittings C叩”’gh1 ASME lntemat;onal Provled by IHS Ma削under 1；伺盹e时馆、 ASME L；伺咱膊，Purd＇υeU耐ers;ty/592司082001. υser•w。闸， hel lo N。repaduc6on or no怕。rkl咱ρemittcd w~hout Ile阳setron、 I HS N。1f0 Re且le. 12/1 31~1701 02:1 1 MST Plastic Push-Fit Drain, Waste, and Vent (DWV) Fittings AN AMERICAN NATIONAL STANDARD A泪县、 ）€※S( t与任这二J The American Society of ~® Mechanical Engineers Two Pa『k Avenue • New York, NY • 10016 USA Copyright ASME lntemalioral Provided by !HS Marki! under license w ith ASM E Licensee=Purdue University/592308200 1, User=world, hello No reproduction o r networking permitted w ithout license from !HS Nollor Resa悟， 1 2/1 3201 701:02: 11 MST Date of Issuance: October 12 2017 This Standa「d will be 「evised when the Society approves the issuance of a new edition. ASME issues written replies to inquiries concerning interpretations of technical aspects of this Standard . Interpretations a「E published on the Committee Web page and under http://go.asme.o「g/lnte「psDatabase. Periodically certain actions of the ASME A112 Committee may be published as Cases. Cases are published on the ASME Web site under the A112 Committee Page at /A112committee as they a「e issued . Errata to codes and standards may be posted on th