Brinno缩时拍寿命终止 (EOL) - TLC100 固件 TLC100 固件升级程序 (一个 A1) 重要的： 请在升级包中阅读固件升级程序之前更新您的相机。说明书用户手册.pdf

Firmware Time Lapse Camera Upgrade TLC100 Procedure version EN A1 Please follow below steps to upgrade your Brinno Time Lapse Camera: Step 1 Ensure your Time Lapse Camera is powered down and remove USB ash drive from the camera. Then insert the USB ash drive into your computer. Power OFF Step 2 Copy and save the le: fw_TLC100.ldr into 100TLC folder in the USB ash drive (100TLC folder should DCIM locate in the DCIM folder) ** If your USB ash drive doesn’t have a folder named 100TLC in 100TLC the DCIM folder, please create those folders by yourself! FW_TLC100.ldr Step 3 Insert the USB ash drive into the Time Lapse Camera. USB Step 4 Power on the Time Lapsed Camera. Insert Power ON Step 5 After the upgrade tool has fully loaded, you will see Green, Red and Blue led lights ash, it means that the camera is updating rmware. Please do not power o camera once led lights begin ashing! DO NOT TURN OFF Done Once the led lights stop ashing and turn o, the rmware update is completed the upgrade. ** The rmware will be removed automatically once the update Finished is completed. Please DO NOT push the power button/ turn o camera ! or remove USB ash drive once the lights begin ashing. That will damage the camera! Supports: customerservice@ 2013.09.16