APC NetBotz Accessories Sensors FD100 External Water Sensor (Sheet)说明书用户手册.pdf

NetBotz FD100 Fluid Detector Thank you for purchasing this NetBotz FD100 Fluid Detector. This sensor has been prepared for use specifically with your NetBotz appliance, and will enable you to monitor a remote location for the presence of any liquid with a resistivity of less than 2 MOhms per cm. (including distilled water). Once you have installed the NetBotz FD100 Fluid Detector and have used the External Sensors task to configure your NetBotz appliance you can use Advanced View and the External Sensors task to ensure that you are notified if fluid is detected. This external sensor can be used only with NetBotz appliances that feature external sensor ports. Note The NetBotz FD100 Fluid Detector package includes the following items: • The NetBotz FD100 Fluid Detector module If the 15-foot cable is not long enough, you can use a NetBotz Extension Cable for External Sensors (available from your NetBotz reseller) to lengthen the cable. Note • Plastic insulator sheet • Cable mounting kit • This flyer Installation To install your NetBotz FD100 Fluid Detector, plug the cable into an available External Port on your NetBotz appliance. Be sure to note the number of the External Port when you connect the cable; you will need it when you use the External Sensors task to configure your NetBotz appliance. The External Port number is printed above the port on the appliance. Note Then, place the fluid-sensing portion of the NetBotz FD100 Fluid Detector at the location that you want to monitor. Be sure to place the side of the NetBotz FD100 Fluid Detector that includes the four fluid sensor contacts so that they are in direct contact with the surface that you want to monitor for the presence of fluid. The FD1