TC686 双线圈大电流霍尔驱动芯片规格书.docxVIP

TC686 TC686 General Two-Coil Fan Driver Data Sheet Rev. 1.1 Descriptions TC686 is an output driver for two-coil BLDC fan or motor and a Hall sensor is integrated in. Beside the magnetic sensor, the device includes an amplifier that amplifies the Hall voltage, a Schmitt trigger to provide switching hysteresis, two complementary open-drain drivers. It also includes an over-temp protector and chopper modulator which enhances the magnetic performance. Placing the device in a variable magnetic field, if the magnetic flux density is larger than Bop, pin DO will be turned on (low) and pin DOB will be turned off (high). This output state is held until the magnetic flux density reverses and falls below Brp, then causes DO to be turned off (high) and DOB to be turned on (low). Features On Chip Hall Sensor 3.5~28V Supply Voltage 1.5mA Operating Current 500mA(Average) Output Sink Current Embedded Clamp Diodes at Outputs Ambient Temp Range:-40C~85C Embedded Over-Temp Protector TO-94 (SIP-4L) Package Typical Applications BLDC Fan BLDC Motor Revolution Counting Speed Measurement Package □ TO94 TC686 Datasheet Rev 1.1 TC686 Datasheet Rev 1.1 PAGE PAGE 2 / 7 Pin Description TC686 TC686 Figure 1: Package and Pin Table 1：Pin Description No Pin Description 1 VDD Power Supply 2 DO Output1 3 DOB Output2 4 GND GND RegulatorThermal Protectionr Regulator Thermal Protection rep p rei rep o fi p h lp ti re o m g h g v C m A h C cS ir D T ir VDD DO DOB Figure 2: Functional Diagram GND Transfer Characteristic V(DO) V(DO) V(DOB) Figure 3: Output of DO/DOB VS Magnetic Field Absolute Maximum Rating (Note1) RJC RJC Thermal Resistance 227 °C/W Symbol Parameter Value Unit VDD Supply Voltage 30 V VDDR Reversed Supply Voltage -30 V B Magnetic Flux Density Un-limited Continuous 500 Io Output Current Hold 600 mA Peak 800 Ta Ts PD Ambient Temp Storage Temp Power Dissipation -40~85 -65~150 550 °C °C mW TJ Maximum Junction Temp 150 °C Note 1: Stresses greater than those listed under Absolute Maximum R