Ibanez依班娜 电吉他 T1802 T1502 tremolo bridge(语言 英文)说明书用户手册.pdf

T1802 / T1502 tremolo bridge Attaching the tremolo arm 1.The tremolo arm employs a snap-in/snap-out design. Hold the corner of the tremolo arm, and press it fi rmly into the arm socket of the base plate. 2.Use the torque adjustment cap to adjust the tightness of the tremolo arm. Turning the cap clockwise will make it tighter, and turning the cap counterclockwise will make it looser. Stud lock EN T1802/T1502 tremolo bridge is equipped with a stud lock function. 1.Insert an HEX key wrench (1.5 mm) through the hole at the top of the stud bolt. 2.Turning the stud lock bolt clockwise, tighten it until the stud lock bolt contacts the anchor nut and will no longer rotate. To release the stud lock, loosen the stud lock bolt. Adjusting the action To adjust the height of the entire tremolo unit, use an HEX key wrench (2.5 mm) to turn the stud bolts located at the left and right of the tremolo unit. To adjust the height of each saddle, use an HEX key wrench (1.5mm). MEMO Make sure that the stud lock is released before you adjust the height of the stud bolt. 1 ➤➤ Adjusting the intonation The intonation can be adjusted by adjusting the saddle forward or backward using a Cross slot(+) head screwdriver. Replacing the strings To replace strings, thread the new strings through the string holes located on the back of the guitar. The strings are then threaded through the tremolo block and up and over the saddle. Adjusting the tremolo attachment angle The tremolo attachment angle is adjusted by changing the balance between the string tension and the tension of the tremolo springs installed on the