三菱 M800V M80V系列编程手册（加工中心系统） EN.pdfVIP

Introduction This manual describes the information for programming on Mitsubishi Electric CNC. Improper handling can cause unexpected malfunctions. To use this device correctly, be sure to read this manual before use. Supported models of this manual are as follows: Supported models Details M800VW Series M850VW, M830VW M800VS Series M850VS, M830VS M80VW Series M80VW M80V Series M80V TypeA, M80V TypeB Abbreviations for model names used in this manual are as follows: Abbreviations Supported models M800V, M800V Series M800VW Series/M800VS Series M80V, M80V Series M80VW Series/M80V Series M800V/M80V, M800V/M80V Series M800VW Series/M800VS Series/M80VW Series/M80V Series M8V, M8V Series M800VW Series/M800VS Series/M80VW Series/M80V Series To safely use this CNC unit, thoroughly study the Precautions for Safety before use. Be sure to keep this manual on hand so that users can refer to it at any time. Also refer to the manuals on Manual List as necessary. Notes on reading this manual (1) The description concerning signals in this manual refers to information transmission between a machine and PLC or between CNC and PLC. The method on controlling the signals (ON/OFF) differs depending on the machine. Refer to the manual issued by the machine tool builder (MTB). (2) Some parameters can be used by end-users and some parameters are set by the MTB according to the specifica- tions. End-users may not be able to set or change some of the parameters described as ... can be set with the pa- rameter #XXXX in this manual