2007丰田camryhv维修手册有电路.pdfVIP

Communication Malfunction (A/C Inverter DTC B1498/98 Local) DESCRIPTION The hybrid vehicle control ECU and compressor with motor assembly transmit information to one another via a communication line. Compressor control is stopped and the DTC is output if communication information is cut off or abnormal information occurs. The DTC is also detected if high-voltage power d from the inverter with conver ssembly to the compressor control circuit is shut off. The output DTC is memorized as previous trouble. CAUTION: • Wear electrically insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Be sure to carry the removed service plug grip because other workers may install it by mistake. • Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed. NOTICE: Depending on the timing of the power supply to the 12 V power supply circuit and high-voltage circuit when the power switch is turned on (READY), an abnormal information signal may be output, causing this DTC to be stored. If the output DTC is a code that was memorized in the past, check the fuses and wire harnesses. If there is no malfunction, erase the DTC. DTC No. DTC Detection Condition Trouble Area • Harness or connector between hybrid vehicle control ECU, compressor with motor assembly, and