塑料滑轮注塑模具设计.docVIP

河北工程大学毕业设计 PAGE PAGE 30 摘 要 该塑料骨架总体形状为回转体，整体尺寸不小，需要大批量生产，为了提高生产率，降低成本，故采用模具成批注射生产。。该模具采用普通浇注系统，由于一模一腔，利用分型面间隙排气，该分型面位于熔体流动的末端利用分型面间隙排气。本模具采用楔紧块与定模板制成一体的整体式结构，牢固可靠性大。利用导滑条导滑。选尼龙(PA6) 关键词：斜导柱 ；斜滑块 ；浇注系统 Abstract The key point of the structure design of plastic injection mould with V-belt pulley groove is the parting(i.e,side action) and eyecting mechanism.Based on the analysis of the technologacical characteristics of plastic pulley,a practical mould structure is presented,involving the design of components of mold and their working principle.To ensure the quality product,the side pulls and