弹性底座配件.pdfVIP

The Cypress of Raleigh 11/21/16 THW 05.11 b. Perform relative humidity test using in situ probes, ASTM F 2170. Proceed with installation only after substrates have um 75 percent relative humidity level measurement. C. Fill cracks, holes, and depressions in substrates with trowelable leveling and patching compound and remove bumps and ridges to produce a uniform and smooth substrate. D. Do not install resilient products until they are same temperature as the space where they are to be installed. 1. Move resilient products and installation materials into spaces where they will be installed at least 48 hours in advance of installation. E. Sweep and vacuum clean substrates to be covered by resilient products immedia y before installation. 3.3 RESILIENT BASE INSTALLATION A. Comply with manufacturers written instructions for installing resilient base. B. Apply resilient base to walls, columns, pilasters, casework and cab s in toe spaces, and other permanent fixtures in rooms and areas where base is required. C. Install resilient base in lengths as long as practicable without gaps at seams and with tops of adjacent pieces aligned. D. Tightly adhere resilient base to substrate throughout length of each piece, with base in continuous contact with horizontal and vertical substrates. E. Do not stretch resilient base during installation. F. On masonry surfaces or other similar irregular substrates, fill voids along top edge of resilient base with manufacturers mended adhesive filler material. G.