RoboMaster 开发板OLED使用说明.pdfVIP

RoboMaster Development Board OLED 开发板 OLED 型 開発ボード OLED User Guide 使用说明 ユーザーガイド V1.2 2018.06 Disclaimer Thank you for purchasing the ROBOMASTERTM Development Board OLED (hereinafter referred to as the Board OLED). Read this disclaimer carefully before using this product. E By using this product, you hereby agree to this disclaimer N and signify that you have read it fully. Install and use this product in strict accordance with the User Guide. SZ DJI TECHNOLOGY CO., LTD. and its affiliated companies assume no liability for damage(s) or injuries incurred directly or indirectly from using, installing or modifying this product improperly, including but not limited to using non-designated accessories. DJI™ and ROBOMASTER are trademarks of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its affiliated companies. Names of products, brands, etc., appearing in this document are trademarks or registered trademarks of their respective owner companies. This product and document are copyrighted by DJI with all rights reserved. No part of this product or document shall be reproduced in any form without the prior written consent or authorization of DJI. The final interpretation right of this disclaimer is reserved by DJI. Warning 1. Visit the RoboMaster official website and download the RoboMaster Development Boards User Manual before use. Read and understand the whole manual, and then strictly follow the instructions in the manual when using the Board OLED. 2. Connect the cables correctly by following the instructions in the RoboMaster Development Boards User Manual otherwise the connectors and the Board OLED may get seriously damaged. 3. Make sure there are no short-circuits and all the cables are in good condition. DO NOT use cables that have been damaged in any way.