文件支架直接瞬态动态分析rd 2020.pdfVIP

RADIOSS, MotionSolve, and OptiStruct Tutorials RADIOSS Advanced S... 第 1 頁，共 7 頁 Direct Transient Dynamic ysis of a Bracket - RD-2020 In this tutorial, an existing finite element model of a bracket will be used to demonstrate how to perform direct transient dynamic ysis using RADIOSS (bulk). HyperGraph will be used to post-process the deformation characteristics of the bracket under the transient dynamic loads. Finite element model of the bracket The bracket is constrained at the bottom of the two legs. Transient dynamic loads are to be applied at the grid points of the top, flat surface of the bracket around the hole in the negative z direction. The time history of the loading is shown in the next figure. The direct transient ysis is run for a total time of 4 seconds with the time being divided into 800 rements (i.e. time step is 0.005). Structural dam has been considered for the model. A concentrated mass element is defined at the center of the spider and z dis cements are monitored at the concentrated mass at the center of this hole. Time history of applied loading file://C:\Altair\hw10.0\help\hwsolvers\rd2020.htm 2009/11/16 RADIOSS, MotionSolve, and OptiStruct Tutorials RADIOSS Advanced S... 第 1 頁，共 7 頁 Direct Transient Dynamic ysis of a Bracket - RD-2020 In this tutorial, an existing finite element model of a bracket will be used to demonstrate how to perform direct transient dynamic ysis using RADIOSS (bulk). HyperGraph will be used to post-process the deformation characteristics of the bracket under the transient dynamic loads. Finite element model of the bracket The bracket is constrained at the b