城镇供水“一户一表”管道工程水力检测及验收技术规程条文说明.pdfVIP

城镇供水“一户一表”管道工程

水力检测及验收技术规程

条文说明

-20-

目次

1总则··································································································································22

3城镇供水“一户一表”管道工程水力检测及验收···············································································23

3.1水力检测的原理·················································································································23

3.4水力检测流程····················································································································23

4城镇供水“一户一表”塑料管管道工程“热熔缩径”现象水力检测及验收·················································25

4.1塑料管“热熔缩径”现象水力检测的原理························································································25

4.4塑料管“热熔缩径”现象水力检测流程··························································································25

-21-

1总则

1.0.1“一户一表”管道工程出现问题的原因可能为：管道漏水、杂物堵塞管道、由施工质量或管材特性引起的塑

料管“热熔缩径”现象、管路布置复杂造成的串户、水头损失增大、设计管径过小等。制定本规程的目的是能对城

镇供水“一户一表”管道工程进行质量检验，对设计管路进行水力复核，减少日后的用水纠纷，最终保障广大城市

供水用户的利益。

1.0.2本条明确了本规程的适用范围。适用于依靠市政管网供水的六层及以下住宅、含六层的复式住宅（即住宅

设计规范中的低层和多层住宅）和公共建筑、公共设施、绿化娱乐设施和工业企业的生活用水的“一户一表”管

道工程。二次加压管道工程水力检测参照本规程执行。

1.0.5与本标准有关的国家标准和其他规范、规定已有的内容，除必要的重申外，本规程中不再重复。

-22-

3城镇供水“一户一表”管道工程水力检测及验收

3.1水力检测的原理

3.1.1本条说明了城镇供水“一户一表”管道工程水力检测的原理。住宅给水管道的设计过程是通过用户的设计秒

流量，选取合适的管径，计算各管段水头损失，在室外给水管网压力给定的情况下复核室内给水系统最不利点所

需压力是否满足。本规程制定的水力检测方法是在用户管道已确定的条件下，提供入户管前端0.28MPa的压力，

检测给水管道是否满足其设计流量。

《城市给水工程规划规范》（GB50282-98）规定：城市配水管网的供水水压宜满足用户接管点处服务水头28m

（即0.28MPa）的要求，相当于将水送至6层建筑物所需的最小水头。

3.1.2建筑生活给水管道的设计秒流量的计算可参考《建筑给水排水设计规范》（GB50015-2003）。

2α系数可查《建筑给