WE900-19961001-有效力矩型钢制公制六角螺母和六角法兰螺母的尺寸要求-中文.pdfVIP

DimensionalRequirementsforPrevailingTorqueTypeSteelWE900

MetricHexNutsandHexFlangeNuts

有效力矩型钢制公制六角螺母和六角法兰螺母的尺寸要求共3页第1页

1996-10-01

1.SCOPE.Thisstandardcoversthegeneralanddimensionalrequirementsforhexagon(M5-M24)andflangedhexagon(M5-

M20)prevailingtorquenuts.

范围。本标准涵盖六角(M5-M24)和法兰六角(M5-M20)有效力矩螺母的一般和尺寸要求。

2.REFERENCES.参考

ISO261-Generalpurposemetricscrewthreads-Generalplan.通用公制螺钉螺纹总计划

ISO965-Generalpurposemetricscrewthreads-Tolerances.通用公制螺钉螺纹—公差

ISO1502-Generalpurposemetricscrewthreads-Gauging.通用公制螺钉螺纹—测量

WE950-Prevailingtorquetypesteelhexagonnutsandhexagonflangednuts–Mechanicalandperformanceproperties.

有效力矩型钢制六角螺母和六角法兰螺母机械和性能

WE990-Surfacediscontinuitiesofnuts.螺母表面缺陷

WX100-FinishSpecification表面处理规范

3.GENERALREQUIREMENTS.一般要求

3.1DIMENSIONSANDTOLERANCES.Thedimensionsandtolerancesofhexagonandflangedhexagonprevailingtorque

nutsmustbeinaccordancewithClauses1-6,Tables1-3,andFigures1and2.

尺寸和公差。六角和法兰六角有效力矩型螺母的尺寸和公差参见1-6条，1-3标和图1和2.

3.2GAUGINGREQUIREMENTS.PrevailingtorquenutsmustsatisfythegaugingrequirementsspecifiedinAppendixA

exceptforthescrewthreadwhichmustsatisfytherequirementsofClause4.

测量要求。有效力矩螺母必须满足附录A中规定的测量要求，除螺钉螺纹必须满足第4条要求。

3.3PROTECTIVEFINISH.Alldimensionsandtolerancesdefinedinthisspecificationapplypriortotheapplicationofthe

protectivefinishexceptwhereotherwisespecified.

保护性表面处理。除另有规定，本标准中规定所有尺寸和公差是指涂覆保护性表面处理之前。

4.SCREWTHREADS.螺钉螺纹

4.1DIMENSIONSANDTOLERANCES.Screwthreads,priortotheinclusionofaprevailingtorquefeature,mustconformto

thedimensionsandtolerancesspecifiedinISO261andISO965toleranceclass6H.

尺寸和公差。螺钉螺纹，

4.2GAUGING.NutsshallassembleaminimumofonefullturnbyhandonabasicGOthreadp