WB900-19960701-沉头、半沉头等螺栓尺寸及其它要求-中文.pdfVIP

FORDWORLDWIDEFASTENERSTANDARDWB900

福特紧固件标准共8页第1页

Date:1996-07-01

GeneralandDimensionalRequirementsofPanHead,RaisedCountersunkHeadandFlat

CountersunkHeadMachineScrews,andMachineScrewandToothWasherAssemblies

盘头，半沉头，沉头螺栓，机用螺钉，齿形垫圈组合件的尺寸及其它常见要求。

1.SCOPE.

Thisstandardspecifiesthegeneralanddimensionalrequirementsofpanhead,raisedcountersunkhead

andflatcountersunkheadmachinescrewsandmachinescrewandmachinescrewandtoothlockwasher

Assemblieswithrecessdrivesystems.CrossrecessdataisshowninAppendixA.Lobedrecessdatais

ShowninAppendixD.

1.范围

本标准规定了使用凹穴拧入方法如盘头，半沉头，沉头螺栓，机用螺钉，齿形垫圈组合件的尺寸及

其它常见要求。附件A为十字槽信息。附件D为花形凹槽信息。

2.REFERENCES.参考标准

ISO261-ISOGeneralpurposemetricscrewthreads-Generalplan.

ISO261-ISO通用公制螺纹—总方案

ISO965-ISOGeneralpurposemetricscrewthreads-Tolerance.

ISO965–ISO通用公制螺纹–公差

ISO1502-ISOGeneralpurposemetricscrewthreads-Gauging.

ISO1502–ISO通用公制螺纹-测量

ISO4762-Hexagonsocketheadcapscrews-ProductgradeA.

ISO4762–六角内凹槽螺栓—产品等级A

ISO7721-Countersunkheadscrews-Headconfigurationandgauging.

ISO7721–沉头螺栓—头部形状及测量

WA900-Dimensionalrequirementsforhexagonandflangedhexagonboltsandscrews,and

hexagonscrewandwasherassemblies.

WA900–六角，六角法兰螺栓，螺钉及垫圈组合件尺寸要求。

WA990-Surfacediscontinuitiesofboltsandscrews.

WA990–螺栓，螺钉表面缺陷。

3.GENERALREQUIREMENTS.常见要求

3.1DIMENSIONSANDTOLERANCES.Thedimensionsandtolerancesofpanhead,raised

countersunkheadandflatcountersunkheadmachinescrews,andmachinescrewandtoothlock

washerassembliesshallbeinaccordancewithClauses1-8,Tables1-4andFigures1-4.

3.1尺寸和公差。盘头，半沉头，沉头螺栓，机用螺钉，齿锁垫圈组合件的尺寸和公差必须满足1-8

条，图1-4，表1-4的要求。

首次采用日期批准更改负责采用