WB980-20051101-喷白漆螺栓性能-中文.pdfVIP

WB980

PAINTCLEARINGSCREWS–PERFORMANCE

喷白漆螺栓-性能—福特全球紧固件标准

共4页第1页

Date:2005-11-01

FOREWORD:DuringtheNovember2005update,Table2andthedesignvariantdiagramswere

revised.DesignationcharacterswerelinedupwithISOconvention.DimensionMwasincluded

forallvariants,dimensionLp(formallyX)wasalignedwithWA900.Noteswereaddedtoclarify

thediagramandtablerequirements.VariantGwasadded.

前言.,本标准于2005年11月做了最新修订,对表2和设计变更图做了修改,字母名称仍延用ISO惯例.所

有变量中都包含了尺寸”M”,WA900,中对尺寸LP(X)也有规定.并增加了区分图表的注释,及变量G.

1.SCOPE:ThisspecificationcoverstheperformancerequirementsofISOmetricscrewswitha

paintclearingfeatureincorporatedatthescrewpointandwithphysicalpropertiesinaccordance

withWA950.

1.范围:本标准包含了ISO米制螺栓末端喷白漆(机械性能满足WA950)的性能要求.

1.1REFERENCES.参考文献

WSK-M64J29-C1-C3-Waterborneelectrocoat电镀

WSK-M6J160-A1Primersurfacer,colored,PUmodifiedpolyester,mediumsolid,165oCbaking

temp.

WSK-M50J111-APaint,mediumsolidpolyester,baking,exteriortopcoat.

2.GENERAL:PreferreddesignsofpaintclearingfeatureareshowninClause5.Otherdesigns

shallonlybeusedifapprovalisobtainedfromtheWorldwideFastenerStandardsCommitteeprior

totheirintroduction.

概要:应首选条款5的喷白漆方案,其它设计方案只有在使用前,获得世界紧固件标准委员会的批准才

可以使用.

3.PERFORMANCETESTING:(Onlyforinitialdesignapprovalandasarefereetestincasesof

dispute)

性能测试:(为避免纷争,要先通过最初设计批准和仲裁实验)

3.1CROSSTHREADINGTEST:Thescrewmustbeinitiallymisalignedwiththecenter-lineofthe

testnutthreadby5°+/-1°andwhenassemblyisattemptedusinga20+/-1Nendloadthescrew

mustnotcrossthread.Thetendencytowardsself-alignmentmustnotbeprevented.

错扣试验:螺栓最初与实验用螺母螺纹中心线的偏离度为5°+/-1,实验组装螺栓螺母时,施加20+/-1

N的终极载荷,不能有错扣现象出现.允许自动定位