【精品】lab1.pdfVIP

Getting Started with System Generator for DSP Lab 1 - Using Simulink Using Simulink Lab Introduction In this lab you will learn the basics of Simulink. You will use a Simulink blockset to generate a simple design and take it through simulation. You will then change the sampling settings to see its effect on the output. You will then learn how to create a subsystem. Objectives After completing this lab, you will be able to: • Use the Simulink tool to create a simple design • Create a subsystem and simulate • Describe the effect of the sampling period Procedure This lab has four primary steps. In Step 1, you are introduced to the Simulink environment. In Step 2, you will analyze the effect of the sampling period. In Step 3, you will create a simple filter design using a Simulink blockset. Finally, in Step 4, you will create a subsystem of the design and perform simulation. Lab 1 - Using Simulink Lab 1-3 1-877-XLX-CLAS Introduction to Simulink Step 1 General Flow for this Lab: Step 1: Step 2: Step 3: Step 4: Introduction Analyzing Creating a Creating a to Simulink Sampling Simple Filter Subsystem Period Effect Design In this step you will become familiar with the MATLAB and Simulink environments (software tools from The MathWorks suite). You will create a blank worksheet, add a Sine Wave source element, add a Scope sink