毕业设计4_恒压变频PLC.pdf

目录 1、 外文翻译 2、 设计任务书 1 （） 设计题目 2 （） 设计目的 3 （） 系统控制要求 2、 设计内容 1 （） 工艺过程 2 （） 设备概述及技术参数 3 PLC （） 系统选型 4 （） 电气控制系统原理图 5 （） 统程序设计 6 （） 参考资料 四、 设计感想、体会、收获 71 一、外文翻译 STEP 1 Select a Counter Type and Operating Mode 2 Specify nitial Parameters 3 Program nterrupting Events/Multiple Steps 4 Generate Code The High Speed Counter instruction (HSC) in LAD or STL is provided by the S7-200 to control events that occur at a rate that is faster than the scan rate of the PLC. The operation of an HSC is very flexible, with multiple initialization options that determine the behavior of the counter. To properly configure an HSC, you need to set several parameters in SM memory, configure a specific HSC for a mode of operation, attach interrupt routines to specific counter events, and, finally, enable the operation of the counter. Note: Your program must be compiled before you use the HSC Wizard. If you have not compiled, the wizard prompts you to do so at the beginning of the HSC configuration process. The HSC wizard queries you for initialization options, and then generates program code and data block code for the specified configuration. After you choose HSC from screen one, the wizard queries you for the following information: STEP 1 Select a Counter Type and Operating Mode Choose a counter to configure from the list box (PLC-dependent). Choose an operating mode from the list box. Your choice of counter determines