乙烯基酯封闭底漆100.docVIP

Intended Uses 用途 主要应用于需要耐强酸，强碱，强氧化物的混凝土或金属材质的基材表面。具体耐腐蚀性能参数见附表。 Mainly used in need of strong acid-resistant, strong base, strong concrete or metal oxide material of the substrate surface. Corrosion resistance of specific parameters, see the annex. Product Information产品简介 乙烯酯树脂底漆，以特殊乙烯酯树脂为主要成膜基料，加入少量活性稀释剂，助剂等施工时按照一定比例加入乙（固化剂），丙（促进剂）组分，混合均匀，对金属和混凝土表面具有极佳的附着力，涂层具有优良的柔韧性，耐温变性和抗疲劳特性。 Vinyl ester primer cantains special vinyl ester and activity thinner assistants etc.Before application, please add componnent A,stir it thoroughly. suited for painting the surface of steel and concrete substrate, excellent adhesion, flexibility, heat-resistant property and durable. Application details 产品数据 Volume Solids 固体份 ≥98% Colour 颜色 无色，也可按照客户要求调配颜色 Transparent or any color according to Custome,srequests Dry Flm Thickness干膜厚度 80-100microns 80-100微米 Theoretical Coverage 理论涂布率 8.5-9.2m2 /Kg 8.5-9.2平方米/公斤 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 Allow appropiate 气温10度 A:B:C=20:05:0.4(by weight ) 气温10度 A:B:C=20:0.4:0.4(by weight ) During mixing and Using ,be sure that it is free from foreign substances 混合和使用过程中应避免混入水等杂质 Induction Time 熟化时间 Not necessary 不需要熟化 Pot Life 使用期 15℃：60min; 25℃:30min; 35℃:15min We can adjust the pot life and drying time according the temperature. 我公司可应客户要求根据涂装环境温度调整使期和涂膜干燥时间 After mix ,please use up it during the Valid time, or it is wasted. 涂料混合后，宜在30分钟使用期内用完，过期不能使用 Clear 油漆设备清洗 The tools shoulded be cleaned immediatedly with afterapplication , or it is difficult to clean them 清洗工作应及时，涂料完全固化后，清洗工作将变得困难。 Drying time and Over coating Interval 干燥时间 覆涂时间 Substrate Temperature底材温度 Touch Dry 表干 （h） Hard Dry 硬干 （h） Completely Cure 完全固化 （d） Over coating Interval 推荐覆涂间隔 Mix最短 Max最长 15℃ 25℃ 35℃ 8 4 2 8 4 2 8 4 2 8 hours 4 hours 2 hours 26 hours 24 hours 12 hours Storageand Handling 贮存与管理