HP-基础培训 操作系统安装 V1.0.pptVIP

Operation SystemInstallation Introduction This chapter is intended as a short guide for the cold installation procedure of an HP-UXsystem. It is based on UX 11.11 (or 11i). If you need more detailed information we stronglyrecommend to refer to the HP’s official installation guide: Installation guides for UX 11.00 or UX 10.20 can also be found on . If you prefer to update your system instead of cold installing it, refer to the Update Chapter in this book. When do you need to do a cold install? There is no operating system installed yet. The installed operation system is corrupt and cannot be repaired. The boot disk is defective and needs to be replaced In the latter two cases, you might want to recover the system from an Ignite-UX tape/server Prerequisites Four basic requirements must be fulfilled in order to be able to cold-install a system: System must be supported Firmware update maybe needed Some systems require a certain PDC (processor) firmware level in order to be bootable with HP-UX 11i. A table of minimum required firmware versions for UX 11.11 can be found in the Update Chapter. Disk space and physical memory need to be sufficient UX 11.11 core needs at least a 4GB root disk, 64MB RAM, 128MB swap space. More is better and strongly recommended Preparation Backup for Failback Backup using fbackup fbackup does not cross NFS boundaries unless specified. Using the normal tape location to do a full backup, insert a new tape and enter: # fbackup -f /dev/rmt/0m -i / -v Later, if you wish to return the system to its previous state, use the frecover command. See the fbackup(1M) manpage for examples. Ignite-UX recovery commands Using make_tape_recovery The Ignite-UX servers make_tape_recovery command creates a bootable recovery tape for an LVM or whole disk file system while it is up and running. # /opt/ignite/bin/make_tape_recovery -Av -d /dev/rmt/0m Ready for installation? Before you install the system you should have the following things ready: Installation