光电器件培训教程.pptVIP

联系人：孙宇 Welcome! ShenZhen BEST OPTO. 深圳市佰思特光电技术有限公司 ——光电器件 撰写人：郑良桃 2005.3.22 Fabry-Perot Laser (FP) Distributed Feedback Laser (DFB) Light Emitting Diode (LED) Vertical Cavity Surface-Emitting Laser (VCSEL) Photo Diode (PD) Pin-Transimpedance (PIN-TIA) Transceiver Abstract 2. Fabry-Perot Laser (FP) Applications ATM SONET/SDH Fiber Channel 785 nm to 1550 nm. ATM and SONET/SDH applications operate at 1310 nm Moderate cost Edge-emitting device Operate in “closed loop” mode Moderate spectral width Threshold currents can range from 5mA to 30mA at room temperature High speed (depending on design) – can be used at data rates from 155 Mbps to 2.5 Gbps Output current (bias plus modulation) must remain above the laser threshold current to avoid turn-on delay and optimize speed Can be used for distances to ~40 km or longer Threshold current and slope efficiency vary significantly over temperature. Therefore, automatic power control (closed loop) is used to maintain a constant average power (using a monitor diode) and some form of temperature compensation is generally used for the modulation current Eye safety is not as big an issue with 1310 nm devices, but becomes important with short-wavelength devices (such as 785 nm) 3. Distributed Feedback Laser (DFB) Applications ATM SONET/SDH Fiber Channel DWDM 10 Gbps 1310 or 1550 nm. WDM applications operate at separate wavelengths around 1550nm High cost Edge-emitting device Operate in “closed loop” mode, Sometimes with TE coolers Internal Bragg grating results in very narrow spectral width (SLM) Threshold currents can range from 5mA to 30mA at room temperature High speed (depending on design) – can be used at data rates from 155 Mbps to 2.5 Gbps Used for longer distance (~20km to 100km) / high data rate transmission Threshold current and slope efficiency vary significantly over temperature. Therefore, automatic power control (closed loop) is used to maintain a cons